Door installation with roll boot and partition methods along

Installing an anti-theft door requires sufficient experience in this field. First, we must point out that the frames of these products are usually produced in the dimensions of 4x10 and 4x8, and the standard floor for the frames is 18 and 20 cm. Also, an important point that you should consider before installation is the dimensions of the door, which have dimensions of 105*210 and 110*215, and you must pay attention to these dimensions before destroying the frame. Stay with us until the end of this article to learn more about how to install these products. Meanwhile, we suggest you visit the anti-theft door page to learn more about these products.

Installation of anti-theft door frame

The most important issue in installing an anti-theft door is to put the frame in its place, which we can do this in two ways, one is to separate the frame from the door and install it separately. Hold the wooden poles of the sutons so that the frame does not move and check the alignment of the work with a plumb line. In the second method, we put the door and the frame in place at the same time and do the alignment again, and after making sure that the door opens and closes, we assemble it in the ways that we will talk about later. . Note that the second method is usually done after building joinery and before painting.

Installation of anti-theft door by partition method

In this method, the waiting frame is installed first, of course, the installation location must be leveled with a plumb line, and then you install the frame and the frame itself. This method of installing an anti-theft door is used less because it is time-consuming, and in addition, it is a bit difficult to re-install it, so we suggest you use this method less. An important point that you should pay attention to is that the waiting frame is completely attached to the ceiling from the top and completely to the floor from the bottom, because otherwise, you may face the problem of the door locking after finishing the work, which is definitely not a problem at all. Your mind does not occur.

The installation method is the roll boot method

In this method of installing the anti-theft door, the frame and the door are installed together in such a way that we put them in the assembly place from the back side that does not have fins, and then from the place of the frame holes on the wall with a sharp object. We mark and then remove the door from the place and after drilling the wall with a driller and making sure that the door is level with a few series of openings and closing it and locking it at the end, we can assemble it with a roll boot. Keep in mind that we must tighten all the roll boots at the same time so as not to damage the alignment of the door. The screw method is completely the same, the only difference is the use of screw bolts instead of roll boots.

Door welding method

In this method, just like the other methods, we must first align the assembly place with the vertical, and then insert the door exactly from the back side into the assembly place, and after the built-in holes on the frame, we weld a few spots, and after testing the door's performance We are doing welding. In this method, make sure the location of the door and its alignment, because if you face a problem after welding, you will have a hard time. Control so that you don't face a problem at the end of the work.

Source : 

Reference site in English